Thingiverse
High Power Rocket Vertical Stands
door jgutz20
15
Downloads
11
Likes
1
Makes
I wanted to make a vertical rocket stand for my larger sized model rockets, Since i had just built numerous horizontal rocket holders for assembly using ½" PVC, i figured i would use the same for this stand.
Start off by choosing how many legs you want your stand to have, i included the options of 3 or 4.
Then print off that same number of the Foot Pads
Grab the appropriate size of Ring and Cap to use
Lengths of PVC for the legs needs to be as close to identical as you can
Length for the vertical portion of ½"PVC can be whatever you want it to be.
Pieces are nice and snug, but can slide in or back out easily into the ½" PVC Tubes, You do not need to glue these in place but of course you can. I actually slid my lengths off of my horizontal rocket holders to take the pictures and make sure everything fits/works.
OD of the parts that slide inside the PVC are 15.75mm (½" is 15.7988) while the outer diameter of those joints are 21.5mm, so it lines
Start off by choosing how many legs you want your stand to have, i included the options of 3 or 4.
Then print off that same number of the Foot Pads
Grab the appropriate size of Ring and Cap to use
Lengths of PVC for the legs needs to be as close to identical as you can
Length for the vertical portion of ½"PVC can be whatever you want it to be.
Pieces are nice and snug, but can slide in or back out easily into the ½" PVC Tubes, You do not need to glue these in place but of course you can. I actually slid my lengths off of my horizontal rocket holders to take the pictures and make sure everything fits/works.
OD of the parts that slide inside the PVC are 15.75mm (½" is 15.7988) while the outer diameter of those joints are 21.5mm, so it lines
jgutz20 publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
