HighGreat Mark Tilting Camera Assembly

This is a set of 3D prints to enable the HighGreat Mark camera to be rotated. The drone needs to be modified as follows:-

1. Remove the 4 plastic patches under the motor arm swivel points (use a sharp knife to lever them up)
2. Unscrew the 4 central screws using a flathead screwdriver.
3. Remove the 2 screws hidden at the centre of the battry box using a torx screwdriver.
Lift off the top.
4. Undo the 2 cross head screws at the back of the pcb and then, carefully(!) slide it back an inch or so making sure that the micro-switch pcb underneath does not become too dislodged.
5. You should see 2 tiny crosshead screws right at the front of the drone buried about half way down. Undo both of these.
6. Remove the starboard ribbon connector (the right one with the drone facing forwards).
7. Finally, you should then be able to slide the camera lens out.
8. Remove the plastic cover from the lens and then replace everything.
9. Once the camera lens is free print this thing, gl