MakerWorld
Signs & Logos
Go to Model
Highland Cow
70
Downloads
45
Likes
44
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 230x153.33mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mmFilaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Jade White: 5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #10 (0.88mm) swap to Blue Gray At layer #13 (1.12mm) swap to Orange At layer #16 (1.36mm) swap to White for the rest.
PAPA Emeritus IV also publishes on
20 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
