Hill compressor Dry-Pac adaptor

Use this with a couple of O-rings to make a dry-pac from hill have 1/8 BSP screw thread for a pipe fitting. Use this on the intake of a compressor with the dry-pack media they sell. I used this for the intake on my hill e3000 compressor to give a little more moisture reduction on the intake side.

I also have filter between the compressor output and the filler probe used to fill the PCP.

The o-ring material is 2.5 diameter material/21mm inside diameter and is streatched over the assembly top and bottom. Silicone grease used to help lubricate. Do not use any other type of grease.

I have a 1/8 BSP 90 degree elbow to fit 10mm tubing. Removed plastic filter on the hill compressor and fitted a 1/8 BSP elbow.

the three screws are M4 x 12 pan heads with washers.

Do not fit the dry-pac to the frame of the compressor. Mount it externally so that the vibrations do not agitate the filter media. This could cause dust and you don't want that getting into your compressor.

Use this