Hillside Tray/Case

Three tray mount designs for the Hillside. The design is intended for a plateless Hillside build. There is 3mm of space beneath the PCB for rubber feet or for 3mm neoprene foam. There are no screws or standoffs.

There is a flat version that is as low profile as it can get. It is roughly just 5mm tall. There is also a wedge version that adds a 3 degree tilt on the inner columns and also a cavity for a battery to go under the PCB instead of under the MCU. The cavity could be widened to allow for larger batteries.

The third version is for adding tenting legs for your optimal typing angle. The legs are added via M3 heat set threaded inserts and then just add your legs of choice via M3 5mm screws.

Inserts: https://www.amazon.com/dp/B07LBRB5HL?psc=1&ref=ppx_yo2_dt_b_product_details