Hinged Deck Box - Magic: The Gathering

by maschine3D · Other Toys & Games

172 Downloads

32 Likes

90 Makes

I adapted the model from tjdesign on Printables by adding the Logo on the lid.In Bambu Studio simple use the paint tool to fill in the logo area. Box Size: 100mm x 68mm x 54mm The model uses 6x2mm magents that are simply glued in place after printing. Hinge Instructions:Slide a piece of filament through the hinge leaving about 1-2mm of excess on each side. Use a flame/heat source to warm the end (1-2seconds max) and then press the hot plastic against a flat surface, locking the hinge into place.