Thingiverse
Hinged Raspberry Pi 4B Case - No Hardware Required
von YaBoiPope
6
Downloads
2
Likes
0
Makes
I couldn't find a Raspberry Pi 4 case that did what i wanted, so I designed my own. Heavily inspired by dtnavida's case (https://www.thingiverse.com/thing:3779674) but modeled from scratch. This features a more reliable hinge closing mechanism that snaps shut and only opens when you want it to. It uses standard 1.75mm filament as a hinge rod.
Only requires support under the lip on the right side of the bottom piece that holds in the Pi 4.
DO NOT USE SUPPORTS ON THE HINGE - IT WILL BE UNUSABLE!
There are 2 variations of each part - one that is ventilated and one that is solid. Feel free to mix and match.
Printed with various Inland, ESun and Sunlu filaments at .2mm layer heights at between 210 and 225c.
Only requires support under the lip on the right side of the bottom piece that holds in the Pi 4.
DO NOT USE SUPPORTS ON THE HINGE - IT WILL BE UNUSABLE!
There are 2 variations of each part - one that is ventilated and one that is solid. Feel free to mix and match.
Printed with various Inland, ESun and Sunlu filaments at .2mm layer heights at between 210 and 225c.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
