History Channel Lightbox

Created a History Channel themed light box for my daughter. Photo is at a slight angle, but lightbox is square and at current size takes up the whole build plate of an A1. Printed the front of lightbox with no purge block with a multiplier of 1.0 without any noticeable color bleeds. I printed once at 0.9 with slight color bleed. You only need to print the front and one of the back box parts. See more about the back of the boxes below. I also included a keyhole cover on the last plate to cover the keyhole if not hanging the box. This cover seems to friction fit pretty well but a little glue would hold it fine. The front of the box snaps into place and to remove it there are two holes on each side to insert the end of a head head wrench into to release the snapped in edge. I just used the the short end on the larger hex head wrench included in the A1 accessory box to push in the snap until it released. I used an LED light strip that was old and I cut to size. Any short LED strip or I wou