HiveIQ Mouse Guard

HiveIQ Mouse Guard I love my HiveIQ beehive, it's doing much better than my wooden hives in the winter. However, the mouse guard that came with it is terrible as you can't add the mouse guard without lifting the whole hive off the bottom board! Then the holes are too small, I had dead drones trying to get out, but they got stuck with their heads sticking out clogging up the whole entrance! So now you got a clogged-up entrance that you can't clean out easily because it's winter and cold so you can't remove the mouse guard, absolutely terrible design!Hence, I made my own mouse guard with bigger holes and you don't need to remove the hive from the bottom board. I made it with a really tight fit, so you shouldn't need to pin it down, the tight fit should keep it in place. I did not optimize the print profile, this comes with just the default settings. I printed mine in PETG, but should work fine with PLA as well, since it's only used during winter.