Thingiverse
Hobby Paint Holder
di Mstr_LunaSea
9
Download
1
Likes
0
Makes
This is a paint holder I have been designing - currently putting it together - would love to see if people have any good remixes for it.
This is for laser cutting - everything is 3mm board except the mid panel, which is 6mm - cut each one once - but cut the shelves one twice.
some advice putting together:
Glue all the shelves into the sides first
then after they are dry then slot them into the mid panel
then glue
wait to dry
then add top and bottom - glue wait to dry
then add back - glue and wait to dry
Also i recommend getting some PVA glue and watering it down once constructed - then brushing it all along the sides, bottom and back - once dry it'll shrink them and holder it all together more firmly.
Ideas for remixes - maybe add paint holders inside, and maybe add a holder so you can tilt the whole thing back (I may add these later after I have more time with prototype
This is for laser cutting - everything is 3mm board except the mid panel, which is 6mm - cut each one once - but cut the shelves one twice.
some advice putting together:
Glue all the shelves into the sides first
then after they are dry then slot them into the mid panel
then glue
wait to dry
then add top and bottom - glue wait to dry
then add back - glue and wait to dry
Also i recommend getting some PVA glue and watering it down once constructed - then brushing it all along the sides, bottom and back - once dry it'll shrink them and holder it all together more firmly.
Ideas for remixes - maybe add paint holders inside, and maybe add a holder so you can tilt the whole thing back (I may add these later after I have more time with prototype
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
