Thingiverse
Hobby sized hand drill.
door forrozza
122
Downloads
77
Likes
0
Makes
Inspired by a push drill and bevel gear assembly i saw on thingiverse. I wondered if i could make a lightweight hand-cranked version of my vintage hand drill. The result is a small hobby drill which takes 2mm to 6mm bits. Smooth running because it uses bearings and the tolerances are fine. this is a tough little drill.
you'll need
2x M3 25mm bolts, washers & nylock nuts.
6x 14mm x 5mm bearings (inner 8mm).
Main body should be at least 50% infill, and all pins, spindles, screws, gears and chuck parts need to be 100%. The handles 20%.
Support used on both spindles and main body.
PLA prefered as its easy to lubricate with 3in1 oil or silicon grease.
ABS can be greased with "Super Lube" silicon grease only, else it disintegrates.
thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/gRHkKDhOVa6
you'll need
2x M3 25mm bolts, washers & nylock nuts.
6x 14mm x 5mm bearings (inner 8mm).
Main body should be at least 50% infill, and all pins, spindles, screws, gears and chuck parts need to be 100%. The handles 20%.
Support used on both spindles and main body.
PLA prefered as its easy to lubricate with 3in1 oil or silicon grease.
ABS can be greased with "Super Lube" silicon grease only, else it disintegrates.
thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/gRHkKDhOVa6
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
