Thingiverse
Holder for case Hdd\Ssd
von marcos971
1
Downloads
2
Likes
0
Makes
Small hdd\ssd case holder, useful for fixing cases in particular places.
Measures:
Total width: 9.80cm
Internal width: 8.20cm
Total length: 12cm
Height: 2.30cm
Internal height: 1.80cm
it was modeled on an Orinco HDD\SSD case model with measurements of 12.8cm\8cm\1.7cm
Fixed with double-sided tape on several sides and in addition the lightness of the structure and the device make it very resistant. Tested for several weeks and still in place.
Printing parameters:
materials at your discretion, PLA works very well and with 10% infill (more would not make sense if not to increase the weight).
If you like it, offer me a coffee ;) :
paypal.me/marcos971v
Measures:
Total width: 9.80cm
Internal width: 8.20cm
Total length: 12cm
Height: 2.30cm
Internal height: 1.80cm
it was modeled on an Orinco HDD\SSD case model with measurements of 12.8cm\8cm\1.7cm
Fixed with double-sided tape on several sides and in addition the lightness of the structure and the device make it very resistant. Tested for several weeks and still in place.
Printing parameters:
materials at your discretion, PLA works very well and with 10% infill (more would not make sense if not to increase the weight).
If you like it, offer me a coffee ;) :
paypal.me/marcos971v
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
