Thingiverse
Holder for GR12 receiver
von Spitpt
21
Downloads
10
Likes
0
Makes
This holder was design to be fix with screws or glued to the support.
you can cut off the two ribs for fixing on a plate or sand them to fit to a rounded fuselage.
The slide is intended for fixing an antenna guide not yet created
you can cut off the two ribs for fixing on a plate or sand them to fit to a rounded fuselage.
The slide is intended for fixing an antenna guide not yet created
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
