Thingiverse
Holder for large filament spools
von jrho
2
Downloads
2
Likes
0
Makes
As You can on the picture I have 2 very large filament spools, and experiments with spoolholder-"feets" with 4 ballbearings gave too much friction.
This model have holders for 2 different sizes of large filamentspools: 52mm inner diameter and 105mm inner diameter. - Do You have rolls with another diameter, You can create some holders and change them whenever You feel like it!
In the middle of the center spool You put a 22mm ball bearing - in each end. And the rod holding it all is a 6mm threaded rod. - The stand is a little thin for a 5kilo role, but its strong enough for printing!
The stl files contains one of each component, so You have to duplicate them in the slicer!
This model have holders for 2 different sizes of large filamentspools: 52mm inner diameter and 105mm inner diameter. - Do You have rolls with another diameter, You can create some holders and change them whenever You feel like it!
In the middle of the center spool You put a 22mm ball bearing - in each end. And the rod holding it all is a 6mm threaded rod. - The stand is a little thin for a 5kilo role, but its strong enough for printing!
The stl files contains one of each component, so You have to duplicate them in the slicer!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
