Holder for Raspberry Pi Zero 2 W

Designed for the Raspberry Pi Zero 2 W, this holder provides a clean, compact, and service-friendly mounting solution for robotics, embedded electronics, and custom maker builds. I made it for my R2D2 project, where I needed a simple way to mount the board securely while keeping all the important ports accessible. The design uses an X-shaped rear support to hold the Pi Zero 2 W firmly in place without adding unnecessary bulk. It keeps the board secure while preserving access to the microSD card, micro-USB ports, mini-HDMI, GPIO header, and camera connector area, which makes wiring, setup, and maintenance much easier inside a tight build. For assembly, I used: 4x heat-set threaded inserts M2.5, OD 3.5 mm, H 4 mm 4x M2.5 x 6 mm screws 4x M2.5 washers The holder itself can simply be glued onto any flat surface, which makes installation quick and practical inside a droid, robot, electronics bay, or compact enclosure. If maintenance is needed later, you can just unscrew the Raspberry Pi fro