Holder for solar shower

I modeled a holder for a solar shower with a cylinder diameter of 120-122 mm. For assembly, you will need a threaded rod with a diameter of 10 mm and an M10 tap to make a thread in the hole (It is for better strength). Then you will need 2 M4 size screws with washers and nuts to tighten the sleeve around the cylinder. M4 screw with a thread length of at least 30 mm. Shorten the threaded rod M10 to your required length. The model is very successful, I will be happy if you take a picture of your assembly and leave a rating. I will be very happy. Thank you M10 threaded rod of your length. M10 tap for creating a thread. 2x M4 screw with a length of 30mm + 2 nuts and 4 washers. You can also use plastic tightening tapes instead of M4 screws.