Hollow-een

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Beige Transmission Distance: 8PLA BambuLab Basic Jade White Transmission Distance: 5PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 5PLA BambuLab Basic Yellow Transmission Distance: 6This print uses 7 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #6 (0.56mm) swap to Blue GrayAt layer #10 (0.88mm) swap to BeigeAt layer #12 (1.04mm) swap to Jade WhiteAt layer #17 (1.44mm) swap to BlackAt layer #19 (1.6mm) swap to RedAt layer #21 (1.76mm) swap to OrangeAt layer #23 (1.92mm) swap to YellowAt layer #25 (2.08mm) swap to Jade Whi