Slicer Discord
Holocron Nightlight – 3D-Druckmodell von Thingiverse Thingiverse

Holocron Nightlight

von daslerpc
225 Downloads
205 Likes
3 Makes
Zum Modell
This is a cube shaped Star Wars nightlight case. When fully assembled, a tilt switch turns the light on when the cube is turned over. When the light is off, the outside faces appear to be blank, but when turned on the light shines through, revealing emblems from four factions in the Star Wars universe.

A writeup on constructing the nightlight and adding electronics to it can be found at http://cmsc838f-s15.wikispaces.com/Star+Wars+Nightlight.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen