Holzmann Anschlag Gleithilfe

For my TS200 tablesaw, I tried it out and improved its thickness for better gliding.
The parallel guide is fastened with its screw. By opening it a little you can move the whole parallel guide, but it shakes by moving. At the rear end of the parallel guide I mounted a small bearing, rolling on the rear rail, maked from wood - there is no thing for printing.
At the rearside the sliding is fine, but behind the handscrew it is shaking.
This part I glued it with doublesided tape on the 18mm end of the clamping bolt and now our printed part helps sliding in the aluminium slot.


Don't know if there is someone out in the world to need this too - enjoy!
perhaps you visit my youtube channel to find diy videos and perhaps you'll improve your german, like I do with english videos.
perhaps you visit my youtube channel to find diy videos and perhaps you'll improve your german, like I do with english videos. Like, subscribe and adopt me.

https://www.youtube.com/c/basteley


Thanks - b