Thingiverse
Homieasy Printer Stand Stabilization Bracket
0
Downloads
0
Likes
0
Makes
I recently purchased the Homieasy Printer Stand with Charging Station off of Amazon (https://www.amazon.com/dp/B0F3D1F7WJ?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3&th=1) and it's been great so far. One of the only issues I've had is that the table will shake when the 3D printer is printing at a high speed. This slight shimmy was causing the prints to not be as accurate as they could be.
These brackets snap onto the posts of the 3D printer table and provide contact to the wall behind. There are two screw holes on each bracket that allow them to be permanently mounted, but in my case, just adding the brackets provided enough stabilization to stop the shimmying without having to screw them into the wall.
Printed with PETG at 50% infill.
These brackets snap onto the posts of the 3D printer table and provide contact to the wall behind. There are two screw holes on each bracket that allow them to be permanently mounted, but in my case, just adding the brackets provided enough stabilization to stop the shimmying without having to screw them into the wall.
Printed with PETG at 50% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
