Honeycomb corkboard frame

i had made one of the led back lit honeycomb storage walls from @MKExpert for my cousin an she loved the design and came back asking if i could take the boarder of that and make it fit a cork board frame so i had a go at it. im not good with cad and can barely use it and i used tinkercad to make this, the space between each piece of the frame is the hard part, so make sure to pay attention to that. use the gap fillers to glue in place to cover the gaps left an this will be what holds the board together and then u print the octagon shaped frame to put ur cork board in. lay that down an put all the pieces on top, use scotch tape to hold all the pieces together an get the spacing right then flip over an add the gap fillers using ca glue or super glue. after all that is done then u can put the octagon cork board frame on top an use the clamping brackets to hold the two together using m3x12 counter sunk screws, 8 clamps 8 screws. over tightening the clamping brackets could cause a gap to ap