Honeycomb Hexagon Coaster

This coaster is two pieces, to allow cleaning of the "drip tray" beneath the honeycomb top. It is about 120mm across, allowing reasonably large mugs to be placed on it.

Print the honeycomb however works, the lines are 0.5mm wide. With Simplify, I needed to make sure the extrusion width was around 0.4mm for it to actually slice the walls. Other slicers may have better success.

For the tray part, I printed it in PETG (the honeycomb is in PLA), which shrunk a little and required scaling to 102% to properly fit. The honeycomb is cut out directly from the tray, so it could be a tight fit at 100% depending on materials.