MakerWorld
Garden
Model downloaden
Honeycomb Planter
6
Downloads
5
Likes
2
Makes
This is a small planter that I designed. There are small drainage holes at the bottom. If you want you can block them up with the slicer. I printed it in PolyMaker ASA yellow. I recommend that you use some UV resistant filaments like ASA, but I think even PLA can hold up pretty well if you have the planter indoors. Enjoy!
lopsided publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
