Honor Pad X8a Wall Mount

Description Wall mount for Honor Pad X8a 11" tablet. Minimalist design that does not disturb and follows the line of the tablet. The power cable is hidden. The small gap between the wall and the tablet allows for better cooling and visually separates any curved wall. This wall pad spacer includes ventilation channels for better cooling of the electronics located in the installation box in the wall. The bracket includes a drilling template for easier placement on the wall and alignment of drill holes. After alignment, this template can be easily removed from the holder, e.g. with a breaking knife.  Assembly procedure Prepare and mark the holes. Use a level to align the bracket and mark the position of the drill holes. The spacing of the holes is 71 mm. If necessary, you can transfer the outline of the holder to the wall for possible cutting or for installation in a material other than plasterboard. Installation of the spacer and cable: Place the spacer on a flat surface and insert the power cable into the prepared slot. Make sure that the ends of the cable are oriented correctly. Then attach the bracket to the spacer using double-sided tape. Make sure that the cable can slide freely in the groove. Stretching the cable: Pull the power cord through the hole in the bracket so that it is ready to connect to the tablet. Attaching the mount to the wall: Use countersunk screws (3 mm diameter recommended) to attach the mount to the wall. Tighten the screws so that their heads are aligned with the surface of the bracket and do not protrude. Prepare the necessary power accessories, such as a POE2USB adapter, Step Down converter, or other power source of your preference. Placing the tablet in the mount: Plug the power cable into the tablet. Insert the tablet into the holder in an angled motion - insert the connector side first, then the other end. Pay attention to the tablet buttons and thin bridges in the holder to avoid damaging them. Securing your tablet: if you're worried t