Hooli Box

My 100% designed Hooli Box Gavin Belson Signature Edition Raspberry Pi 4 Case.

This case is designed specifically for the Raspberry Pi 4 (dual HDMI).

There is a compartment for a 2.5" SSD drive OR you can opt for an M.2 NVMe SSD enclosure.

The top of the case has a vent and mounting holes for a 24mm fan. The one I used came with the RPi4 Canakit. It just barely clears the GPIO pins, but sits right above the CPU.

This case comes with two keystone jacks to extend your choice of USB or network to the back panel. I admit, this case is VERY cramped. I may update it with a bit more room.

The front panel has the Hooli logo on the left and Gavin Belson signature on the right. Suggestion: print the last layer with a different color to really pop the "h" and the signature. Both are at the same height.

The screws needed are:

Front panel: 4 x (M3x8) screws
Top fan (Canakit 24mm fan): 4 x (M3x12) screws AND 4 x M3 nuts
RPi Board: 4 x (M2x8) screws OR (M3x8 but you'll need to