Thingiverse
Hose Quick Connect Cap
von heliguy1971
3
Downloads
3
Likes
0
Makes
A cap for the male end of a common hose quick connect set. The cap snaps on and stays in place well. I plan to use this on my RV sewer tank flush port.
While optional, using a common 1/2in OD x 3/8in ID x 1/16in thick O'Ring stretched over the center post and pushed to the bottom helps to seal the cap near water/air tight if using the cap for the RV scenario above.
I printed in PETG due to outdoor use and better heat tolerance.
No Supports needed.
* Printed with 5 walls/shells
* 5 top / bottom layers
* 20% infill (cubic)
It's about an hour long print.
While optional, using a common 1/2in OD x 3/8in ID x 1/16in thick O'Ring stretched over the center post and pushed to the bottom helps to seal the cap near water/air tight if using the cap for the RV scenario above.
I printed in PETG due to outdoor use and better heat tolerance.
No Supports needed.
* Printed with 5 walls/shells
* 5 top / bottom layers
* 20% infill (cubic)
It's about an hour long print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
