Thingiverse

HOT BED/END POWER MODULE ENCLOSURE

by labidus

4 Downloads

0 Likes

1 Makes

I tried others design out there but cannot make it work for a 40mm of 11mm/16mm of thickness.

So after wasting PLA, I decided to make one that work with 40mm fan with thickness of max 16mm.

The bottom have m3 holes in a grid layout of 10mm between each holes. Should work fine for any design out there...

This thing come with 3 STL, one for the COVER, the 2 others are the enclosure for HOT BED and HOT END. The only difference between these 2 are the name on the box :).

I put the fan in outtake mode, so the hot air are suck outside, at the same time new air are coming from the vent holes.

Hope you like it.

enclosure hotbed hotbed module hotend hot bed hot end module power enclosure hotbed hotbed module hotend hot bed hot end module power enclosure hotbed hotbed module hotend hot bed hot end module power

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format