Thingiverse
Hot End Fan Duct Bracket
door gemorgan
2
Downloads
4
Likes
0
Makes
This bracket sits in between the 40mm fan and the hotend/print cooling duct found here
https://www.thingiverse.com/thing:839620
It then attached to the hot end mount found in Styx i3 (its not currently in here but it will be)
https://www.thingiverse.com/thing:1157231
The duct worked well on its own initially but became a became a bit loose after a while and popped off a couple of times during printing, so I made a bracket to hold it in place.
https://www.thingiverse.com/thing:839620
It then attached to the hot end mount found in Styx i3 (its not currently in here but it will be)
https://www.thingiverse.com/thing:1157231
The duct worked well on its own initially but became a became a bit loose after a while and popped off a couple of times during printing, so I made a bracket to hold it in place.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!