HOTAS Chair Mount

Update 11/7: I've redesigned the interface arms. There are two versions one with a little more reinforcement than the other. I recommend V3 unless you need the extra articulation the V2 can provide. The pitch adjust body was also modified a bit to give more articulation in the pitch axis.

11/4: After some testing I feel this is in a "release" state. IF YOU DOWNLOADED BEFORE THIS UPDATE THE THREAD TOLERANCES WERE OFF AND I SUGGEST A REDOWNLOAD. Photos are of the first revision, the current revision has been trimmed down on size, specifically on the arm clamp, to use less filament and time printing. I've also included a model for a Saitek/Logitech X52 Pro (should work with non-pro as well). I just used 1/8" (3mm) aluminum to make a mounting plate.

For one set you will need to print one of each stl, except the nuts and Interface Arms. For the nuts you will need to print three of them. For the interface arms you will only need to print either the V2 or the V3, not both. I've designed