Thingiverse
Hotbed Spacers
door Gadg3D
30
Downloads
6
Likes
0
Makes
These spacers apply more tension (3mm raise)to the bedsprings for levelling the hotbed.
When my bed was levelled the turning knobs where to loose (they almost fell off) so the smallest vibration could change my bedlevel.
NOTE: for the spring in the left rear corner, where the connector is, use BedVeerVerhoging2.
It doesn't has the higher edge on it.
When my bed was levelled the turning knobs where to loose (they almost fell off) so the smallest vibration could change my bedlevel.
NOTE: for the spring in the left rear corner, where the connector is, use BedVeerVerhoging2.
It doesn't has the higher edge on it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
