Thingiverse
Hotend cable holder
von damt1974
3
Downloads
6
Likes
0
Makes
Holders for my hotend cable. Needed something clean.
attache v1 is to hold the center of the cable --> move the head near the bed to see where you can put it.
attache cable 2 is the part you fix on the 2020 aluminium up-part.
bout de cable 1 and 2 are the parts for the end of the cable (print 2 times of each). Suitable for 3mm cable (i used 3mm coated metalic cable) for the look.
sorry for my bad english!
attache v1 is to hold the center of the cable --> move the head near the bed to see where you can put it.
attache cable 2 is the part you fix on the 2020 aluminium up-part.
bout de cable 1 and 2 are the parts for the end of the cable (print 2 times of each). Suitable for 3mm cable (i used 3mm coated metalic cable) for the look.
sorry for my bad english!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!