Thingiverse
Hotend mount for input shaper
von dont-knock-it
10
Downloads
7
Likes
0
Makes
ADXL345 Hot End Mount
----------------------------------
I wanted a mount that would be as close to the nozzle as possible, and was surprised that no one else had added a simple bracket that could slip over the hot end. This one is designed to slip over the heater block of my ender 3 v2 and is intentionally thicker to allow for the M3 socket head screws to clear the bottom.
Mine was printed in PLA at .2mm layer height. Obviously, let the hot end cool before using it.
----------------------------------
I wanted a mount that would be as close to the nozzle as possible, and was surprised that no one else had added a simple bracket that could slip over the hot end. This one is designed to slip over the heater block of my ender 3 v2 and is intentionally thicker to allow for the M3 socket head screws to clear the bottom.
Mine was printed in PLA at .2mm layer height. Obviously, let the hot end cool before using it.
dont-knock-it veröffentlicht auch auf
21 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
