Hotend wire Guide for Anycubic Mega S

The idea published by Scigola (https://www.printables.com/model/151610-anycubic-i3-mega-sostegno-cablaggio-estrusore) is pretty good! However, the Anycubic i3 Mega S is shipped with a 12mm Diameter wire sleeve. This and the bowden tube often get tangled up in the Z-portal. That's why I adopted the fundamental idea and designed it for the larger sleeve diameter and angled it back to give the wire harness and the bowden tube a push to the rear. Much better than plates at the frame which usually don't work well either. As there is close to no space it took me a few attempts to find a solution which works. Nice side effect: as longer I tinkered around as simpler it turned out, fast to print and with a print orientation which makes it less prone to breakage. No idea whether the original allows full print height but I seriously doubt it. All I used from the original design was the bracket which I butchered a bit.

Print parameters:
0.15mm layer height and adaptive layers
Infill 30% cubic