HotShot Shock Housing

A replacement for the Tamiya HotShot shock/damper housing. You are able to use the adjuster ring and end stops together with the original parts.
The top cap parts however should be printed as a pair and mated as such.
There is not as much detail as on the original part. Maybe in the future I will post a version with reinforcing ribs, like the original, it all depends on how well the part holds up under real world conditions.

The adjuster has a very tight fit so best to use a round file or sandpaper to clean any edges. Often tiny edges will appear at the side of the part that was on the printbed. These edges are only 0.1 mm or less, but in this case, they can make a lot of difference.