Thingiverse
HotShot Stabilizer Mounts
door Qbee
3
Downloads
2
Likes
0
Makes
A set of plates and arches for the HotShot stabilizer arm mounts.
Be aware that although the width of the plates is designed at 16mm, it can be much wider on an FDM printer. Mine came out at around 16.3 to 16.4mm. So I did need to clean them up with a file. If you do not do this, the effect is that your gear box will not properly close anymore. So be sure to measure after printing. The holes in the plates are designed at 1.8mm to get a good fit with the screw. The holes in the arch are at 2.2 to get an easy install.
Be aware that although the width of the plates is designed at 16mm, it can be much wider on an FDM printer. Mine came out at around 16.3 to 16.4mm. So I did need to clean them up with a file. If you do not do this, the effect is that your gear box will not properly close anymore. So be sure to measure after printing. The holes in the plates are designed at 1.8mm to get a good fit with the screw. The holes in the arch are at 2.2 to get an easy install.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!