Thingiverse
Hotwire Cutter Body
par MakeItWithCalvin
7
Téléchargements
4
Likes
0
Makes
This is a basic hot-wire cutter body I came up with for a foam cutting project.
I printed the model with standard print settings as it does not not need to look very pretty. If the rods are a tight fit into the hole use a bit of sandpaper to open the holes up. You do want to make the fit snug so the rods do not move.
Other items required:
3/16" brass rods for holding the wire
cutting wire http://a.co/2X1GD37 (what I used)
12V high amp power source (using an old computer power supply)
heatshrink tubing to hold the wire to the rod
I printed the model with standard print settings as it does not not need to look very pretty. If the rods are a tight fit into the hole use a bit of sandpaper to open the holes up. You do want to make the fit snug so the rods do not move.
Other items required:
3/16" brass rods for holding the wire
cutting wire http://a.co/2X1GD37 (what I used)
12V high amp power source (using an old computer power supply)
heatshrink tubing to hold the wire to the rod
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
