Hover Rider Captain (28mm)

Hi all,

A model I tinkered based on a TTS mesh :
- added most of the details
- remodelled the whole engine/tubes
- made a whole new pilot based on a "prime soldier", and gave him some captain attributes
- used the melta from my bikers model

Should be fairly easy to print, with supports.
use some 1.75 filament bits for assembly pins.

Some Cura must-have settings :
- union overlapping volumes
- supports : Zigzag (15% density minimum) + support roof, let a Z support spacing of 1 layer
- layer recommended 0.1mm or less

Let me know if you wish specific variants !

= Please consider sending a tip if you like my printable models ==

Copyright infringement is not intended. Parts are created freehand in 3d modeling software, no copyrighted product had been scanned or copied in any way. These models are for personal use as proxies and should never be sold. If it causes copyright issues, i will remove it.