Thingiverse

HoverBot Nano EF-02 Front Mount

por vjapolitzer

19 Descargas

10 Likes

0 Makes

A front mount for the Eachine EF-02 FPV AIO camera! 20 degree camera angle. Just clears those props. The LEDs are visible from the bottom! Also, an antenna guard to protect the cloverleaf antenna. The spacer is for the rear screws, so that they come down the same as the front screws with the mount.

My weight without battery is 46.21 grams.

Dissatisfied with the VM275T, I wanted to try something different. I sometimes have a hard time flying outdoors with the VM275T, with the horizon nicely exposed, but the ground being completely dark. The EF-02 seemed like it might handle wide dynamic range a bit better, from videos I have seen. Plus it has a 1/3 inch CMOS! The cloverleaf antenna should provide a slightly better signal, while still being roughly the same weight as the VM275T. Tucking the camera in the front of the drone should be a nice way to keep it protected, and it makes room to put the cloverleaf antenna on top with a guard, without sticking up too much. The LEDs are on the

camera mount Eachine Eachine EF-02 Eachine EF02 ef-02 fpv camera mount micro-quad microquad micro quad micro quadcopter Quadcopter camera mount Eachine Eachine EF-02 Eachine EF02 ef-02 fpv camera mount micro-quad microquad micro quad micro quadcopter Quadcopter

Fuente

Thingiverse

Lo que necesitas para imprimir: Intermedio Baja confianza

Pieza única Tornillería requerida

Soportes 1/3

Ensamblaje 0/3

Ajustes 1/3

Tamaño de cama 0/3

Postproceso 1/3

Impresora

FDM / FFF

Formato de archivo