Thingiverse
HP Cryochamber - external cpu radiator
por neolamb
3
Descargas
7
Likes
0
Makes
WORK IN PROGRESS (and thus corrections)
Hey guys, previously I remixed a CPU rad support to take my radiator out of my case, it was at an angle to avoid pushing/pulling hot air to/from the case, today i decided to go full HP Cryochamber, i've designed theese pieces that you can join with screws or something similar.
This is designed for my Cooler Master case (or more or less any case) with top dimensions of 428mm by 230mmn
This design has some support in the upper part for a future Grille that i will install on top of the fans to avoid dust getting in
It has to be flipped upside down to be printed
I've tried to modify most hangouts so you need less support.
You need to print 2 fan ducts, they can be screwed between them, and to the right and left side, (on the upper edge) then the lower edge lies on top of the case
Ideas are welcome, if you want the F360 files i can upload them !
Hey guys, previously I remixed a CPU rad support to take my radiator out of my case, it was at an angle to avoid pushing/pulling hot air to/from the case, today i decided to go full HP Cryochamber, i've designed theese pieces that you can join with screws or something similar.
This is designed for my Cooler Master case (or more or less any case) with top dimensions of 428mm by 230mmn
This design has some support in the upper part for a future Grille that i will install on top of the fans to avoid dust getting in
It has to be flipped upside down to be printed
I've tried to modify most hangouts so you need less support.
You need to print 2 fan ducts, they can be screwed between them, and to the right and left side, (on the upper edge) then the lower edge lies on top of the case
Ideas are welcome, if you want the F360 files i can upload them !
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
