HPDR - Hydration Pack Dryer Rack

The HPDR or Hydration Pack Dryer rack is designed to make drying your pack's hydration bladder easier. Nothing worse than leaving it with old water or worse hydration mx and forgetting about it for weeks or more and then having a nasty moldy bladder. In the past, after washing my bladder I'd just stuff it with paper towels and be good to go …. well until you're in a hurry and forget to take one of the paper towels out and well it doesn't end well. Prints in multiple pieces to get the appropriate height and a favorite of bladders as long as the mouth open is 5 inches or more (ie USWE 2 liter bladders are what I designed this around) You will need 2 M4x25mm bolts, 2 M4 nuts for the base pieces, and 1 M4x12mm bolt for the hook ( do not over-tighten this one as it should swivel. SEE PICTURE FOR ASSEMBLY GUIDE - The printed pins are friction fit and may be snug or loose depending on how dialed your printer is. You can either sand them slightly if too snug or add a drop or su