Thingiverse
Hubsan X4 Clone
door Pattison_Engineering
31
Downloads
19
Likes
0
Makes
Micro quadcopter designed to be used with Hubsan FC (or other - e.g. AlienWii) and 8 mm motors.
Motor holes are currently 8.5mm to allow for clearance
FC mounting holes are 2.5mm diameter, 20mm square (For AlienWii).
02/21/15 UPDATE: Latest build does not fly well. I found that the motors do not sit level or perfectly vertical; Consequently it is very twitchy and drifts and wobbles a lot when there is not control input. Yes I did recalibrate the FC. I believe that this has something to do with the consistency of the 3D printing. The arms are quite flexible and are also slightly warped and twisted despite the heated bed that I printed one. I'll post another update if I figure out a solution.
This is obviously a work in progress and will change without notice.
Motor holes are currently 8.5mm to allow for clearance
FC mounting holes are 2.5mm diameter, 20mm square (For AlienWii).
02/21/15 UPDATE: Latest build does not fly well. I found that the motors do not sit level or perfectly vertical; Consequently it is very twitchy and drifts and wobbles a lot when there is not control input. Yes I did recalibrate the FC. I believe that this has something to do with the consistency of the 3D printing. The arms are quite flexible and are also slightly warped and twisted despite the heated bed that I printed one. I'll post another update if I figure out a solution.
This is obviously a work in progress and will change without notice.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
