Thingiverse
Replacement Parts
Voir le modèle
Hue Outdoor Motion Sensor Ceiling Mount v2
16
Téléchargements
11
Likes
0
Makes
# Hue Outdoor Motion Sensor ceiling mount v2
Rotate the cap and main body appropriately: 180 degress for the cap, 90 degrees (on its back) for the main body.
The cap can be screwed to the ceiling with a single 3.5mm countersunk screw, allowing it to be oriented to the desired direction also.
The main body then just clips in to the cap. It can be further secured using a tie-wrap (zip-tie) or a small nut/bolt if desired because of the through-hole.
Use supports when printing.
I've included a removal tool to use with pliers but you should only need to squeeze the cap with full-size (not needle nose) pliers and a firm(ish) pull to release the cap from the main body.
Rotate the cap and main body appropriately: 180 degress for the cap, 90 degrees (on its back) for the main body.
The cap can be screwed to the ceiling with a single 3.5mm countersunk screw, allowing it to be oriented to the desired direction also.
The main body then just clips in to the cap. It can be further secured using a tie-wrap (zip-tie) or a small nut/bolt if desired because of the through-hole.
Use supports when printing.
I've included a removal tool to use with pliers but you should only need to squeeze the cap with full-size (not needle nose) pliers and a firm(ish) pull to release the cap from the main body.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
