HueForge Astronaut 2.0

This picture of an Astronaut was made using HueForge. It requires 8 colors Black, Blue, Gray, Muted Blue, Beige, Light Blue, Orange, and White. I used a lot of Matte colors for this print because the colors seem to blend well together. Matte also helps reduce stringing on the print, but you can use normal PLA if that is all you have. Please keep in mind depending on the brand and shade of your PLA your results may vary. Print at 100% infill with a layer height of 0.08, the first layer needs to be 0.16, and a wall loop of 1.I did not use a prime tower, it is not needed. This print should take about 4h23m if you use the 3mf settings. Note: If you only have one AMS you can still print this card. This is how you do 8 colors on one AMS. You put the color changes in the side bar where you can see the layers. Now when you go to program your AMS, you pick the 1st 4 colors in bay1 through bay4. The 5th color goes in bay1 once the black in bay1 is done and so on. You just take out the black and