Hueforge Goku Supreme

Project: daima.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 255.01x143.5mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.9mm and the Actual Depth is 2.6mmFilaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA Sunlu Meta red Transmission Distance: 7 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Beige Transmission Distance: 8 PLA PolyLite White Transmission Distance: 5This print uses 5 unique filamentsSwap Instructions: Start with Black At layer #12 (1.04mm) swap to red At layer #18 (1.52mm) swap to Yellow At layer #22 (1.84mm) swap to Beige At layer #29 (2.4mm) swap to WhiteThis slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it. At layer #33 (2.72mm) swap to Black for the rest.