HueForge Mimikyu 70HP

Love Pokémon cards? Well you can make your own now. This Mimikyu card was made using HueForge. It requires 5 colors Black, Light Purple, Pink, Yellow, and White. I used all Matte colors for this print because the colors seem to blend well together. Matte also helps reduce stringing on the print, but you can use normal PLA if that is all you have. Please keep in mind depending on the brand and shade of your PLA your results may vary. Print at 100% infill with a layer height of 0.08, the first layer needs to be 0.16, and a wall loop of 1.I did not use a prime tower, it is not needed. This print should take about 2h39m if you use the 3mf settings. Swap Instruction are as followed: Start with BlackAt layer #9 (0.80mm) swap to Light Purple (If you use a normal Purple it will come out a lot darker and may not look as good)At layer #13 (1.12mm) swap to PinkAt layer #16 (1.36mm) swap to YellowAt layer #20 (1.68mm) swap to white Happy Printing! Note: If you only have one AMS you can still print