HueForge Owl

This picture of an Owl was made using HueForge. It requires 5 colors Black, Dark Gray, Light Brown, Light Gray, and White. I used all Matte colors for this print because the colors seem to blend well together. Matte also helps reduce stringing on the print, but you can use normal PLA if that is all you have. Please keep in mind depending on the brand and shade of your PLA your results may vary. Print at 100% infill with a layer height of 0.08, the first layer needs to be 0.16, and a wall loop of 1.I did not use a prime tower, it is not needed. This print should take about 4h18m if you use the 3mf settings. Swap Instruction are as followed: Start with BlackAt layer #7 (0.64mm) swap to Dark GrayAt layer #12 (1.04mm) swap to Light BrownAt layer #14 (1.20mm) swap to Light GrayAt layer #19 (1.60mm) swap to White Happy Printing! Note: If you only have one AMS you can still print this. This is how you do 5 colors on one AMS. You put the color changes in the side bar where you can see the laye