HueForge PewPew Chicken

Project: pewpew.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.1mmFilaments Used: PLA+ Elegoo Rapid Black Transmission Distance: 0.4 PLA Ender fast blue grey Transmission Distance: 1.8 PLA+ ESun orange Transmission Distance: 5.8 PLA+ ESun yellow Transmission Distance: 4.1 PLA+ ESun cold white Transmission Distance: 3.2This print uses 5 unique filamentsSwap Instructions: Start with Black At layer #10 (0.88mm) swap to blue grey At layer #14 (1.2mm) swap to orange At layer #19 (1.6mm) swap to yellow At layer #21 (1.76mm) swap to cold white for the rest.