Hueforge Stormtrooper Samurai

My first try with the hueforge software. the original is 200x200 but you can adjust the x and Y but do not change the Z height as this will have an impact on the layer colloring. Project: Stormtrooper Samurai.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mmFilaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA PolyLite Grey Transmission Distance: 1 PLA PolyLite White Transmission Distance: 5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #8 (0.72mm) swap to Blue Gray At layer #13 (1.12mm) swap to Grey At layer #20 (1.68mm) swap to White for the rest.