Hueforge Sunflower

Description Hueforge Sunflower. This model is thicker than default hueforge prints, so it is nice and sturdy on it's own. It will take a little longer to print, but it is worth it. You can print this with 1 AMS if you set both your black and your white filaments to print from the same slot. Just wait until it is done printing the black sometime before it starts printing the white, swap the black spool out for the white.   Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA+ Sunlu Black Transmission Distance: 0.6 PLA PolyLite Brown Transmission Distance: 0.5 PLA BambuLab Basic Orange Transmission Distance: 10 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA+ Sunlu White Transmission Distance: 5 Swap Instructions: Start with Black At layer #11 (0.96mm) swap to Brown At layer #17 (1.44mm) swap to Orange At layer #32 (2.64mm) swap to Yellow At layer #37 (3.04mm) swap to White for the rest.