Thingiverse
Huge Knitting Needle
von mribble
38
Downloads
51
Likes
0
Makes
This is the tip and base of a knitting needle. Then you use a piece of 1.5 inch pvc to finish the needle.
The Fusion 360 file uses parameters and you can just adjust the ID and OD of the pvc so this can fit any size PVC pipe.
There is a video about this project at: https://youtu.be/KSbjwRiPxvE
The Fusion 360 file uses parameters and you can just adjust the ID and OD of the pvc so this can fit any size PVC pipe.
There is a video about this project at: https://youtu.be/KSbjwRiPxvE
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!